Intergas XTREME 36 - Page 51

51
To apply the clock program
► From a boiler that is in standby or in operational mode tap
just above the power LED to access the main menu (also
see §8.1.1).
► Tap on the Domestic Hot Water button
. The current
temperature of the central heating water is displayed in the
le display. Tap the Domestic Hot Water button
again to
switch to the clock program setting.
► Using the Plus and Minus buttons, set the desired
program setting (P-on, On, Eco or O).
► Tap the Enter button to confirm. The chosen program
setting will be saved in the boiler controller. Aer 2 minutes
of inactivity changes made will also be saved.
A P appears in the right display and the display returns to
the Central Heating menu.
Note: By tapping just above the power LED instead of the
Enter button the display returns to the Domestic Hot
Water menu without storing any changes.