Intergraph TDZ 2000 GL2 - Setting Up the Software

To Next Page

To Previous Page

2 Setting Up the Software

Follow the instructions in this chapter to set up the operating system and associated system

software on your TDZ 2000 GL2 or ExtremeZ GL2 workstation.

NOTE If you are setting up an ExtremeZ workstation for the first time, see the

ExtremeZ Customer

Welcome Letter

. The

ExtremeZ Customer Welcome Letter

provides step-by-step instructions

for initial setup of an ExtremeZ workstation. Use the information in this chapter only if you

have to reinstall the operating system and associated system software on your ExtremeZ

workstation.

Preparing for Setup............................................................................................................ 10

Pre-Installed Software.......................................................................................... 10

Before You Start Setup......................................................................................... 10

Starting Operating System Setup........................................................................................ 12

Finishing System Setup...................................................................................................... 13

Creating a Repair Disk ......................................................................................... 14

Creating System Software Backup Diskettes......................................................... 14

What’s Next?..................................................................................................................... 14

Other manuals for Intergraph TDZ 2000 GL2