67
Installing Windows NT Workstation 4.0
Depending on your system’s configuration, you will need some or all of the following system
software during the installation process:
u
SCSI adapter driver
u
Video display adapter driver
u
Network adapter driver
u
Sound adapter driver
u
QFE update software
Follow the instructions in Start Here to install Windows NT.
Do the following during installation of the operating system:
u
Select Custom Setup when prompted to select a Setup type.
u
On a system with internal SCSI disk drives and a SCSI adapter, press the S key to install
the SCSI adapter driver from backup diskette. Select Other (Requires disk
provided by a hardware manufacturer) from the list and press
ENTER. Insert
the diskette with the SCSI adapter driver into the floppy disk drive, and then press
ENTER.
u
Specify a driver for the CD-ROM drive by pressing the S key and then selecting IDE
CD-ROM (ATAPI 1.2)/ PCI IDE Controller from the list.
u
On single-processor systems, when prompted, select Standard PC. This will load the
single-processor kernel and HAL, providing better performance.
On dual-processor systems, if prompted, select MPS Multiprocessor. This will load
the multi-processor kernel and HAL, enabling the system to take advantage of the
second processor.
u
Allow Setup to configure the network only if you have an installed network adapter, and
only if the system is connected to the network.
u
Create an Emergency Repair Disk when prompted to do so.
Do the following after installation of the operating system:
u
Install drivers or other system software from any backup diskettes. System software
delivered on backup diskette is usually more current than system software on the
operating system CD-ROM. Alternatively, you can install the drivers or other system
software from the Windows NT CD-ROM if you do not have them on diskette.
To Next Page
Loading...
