36
Mark Events As Read
After you have viewed the contents of the DMI event log, highlight this setting and press
ENTER to mark all DMI events as read.
Clear All DMI Event Logs
Selecting Yes for this setting will clear the DMI event log after the system reboots. The
default setting is No.
Multiboot
Use this option to display additional setup menus to configure system boot devices. Press
ENTER to display the multiboot submenu. This submenu provides the following options:
Hard Drive
Selecting this option tells the system to boot from the system’s hard disk drive only.
Removable Devices
Selecting this option causes the system to boot from the specified order. To change the
order, highlight an option and use the plus or minus keys to move the option up or down in
the list.
Power Management
Use this selection to display additional setup menus to control the power management
functions of the system. To configure the Power Management functions, highlight this
option and press
ENTER. A submenu displays, as shown in the following figure.
To Next Page
Loading...
