24
Starting BIOS Setup
To start BIOS Setup:
1. Restart the system. When the system is started, an Intergraph Computer Systems logo
displays.
2. Press the
F2 key to start BIOS Setup.
NOTE You can only start BIOS Setup during the boot sequence.
NOTE You can set a password to prevent unauthorized users from accessing BIOS Setup. See
“Features Screen” in this chapter.
While using BIOS Setup, remember these tips:
u
To move between screens in BIOS Setup, press the right and left arrow keys.
u
To move between options on a screen, press the up and down arrow keys.
u
To configure a BIOS setting, use one of the following methods:
−
Highlight the setting, and press
ENTER to display a list of possible values. Use the
up and down arrow keys to select a value, and then press
ENTER again to select it.
−
Highlight the setting, and use the plus or minus keys to increase or decrease its
value.
u
When you are in a menu in BIOS Setup, press ESC to exit.
u
When you are ready to exit BIOS Setup, use the Save Changes and Exit option to exit
and save your BIOS settings.
BIOS Setup has six primary configuration screens (listed across the top of the screen):
u
Info
u
Main
u
Advanced
u
Chipset
u
Features
u
Exit
Each of these screens is described in the remaining sections of this chapter.
To Next Page
Loading...
