21
If the listed modem is incorrect, you must install the appropriate driver for your modem,
located on the CD-ROM or floppy diskette media that accompanied the modem. Click
the Change button, then click the Have Disk button, and insert the driver media into the
appropriate drive. Follow the prompts to install the new driver.
Changing Hard Disk Drive Letters (Windows NT)
If you have more than one hard disk drive, you may need to reassign system drive letters.
You can also reassign the CD-ROM drive letter, if needed.
To change drive letters:
1. From the Start menu, click Programs, Administrative Tools, and then Disk
Administrator.
2. Select a hard disk drive.
3. From the Tools menu, click Assign Drive Letter.
NOTE If you select the current drive or an otherwise locked drive, you must restart the system to
complete the drive letter reassignment.
4. Select a new drive letter to assign to the hard disk drive from the list. Click OK, and
then click Yes to continue.
5. If necessary, click OK, and then click Yes.
6. Repeat steps 2 through 4 for each hard disk drive letter assignment that you want to
change.
7. Click Partition, then click Exit. If necessary, restart the system to complete the drive
letter reassignments.
Changing Virtual Memory Settings (Windows NT)
If you have more than one hard disk drive, you may need to change size and location of your
virtual memory page file. See Windows NT Help for more information.
Consider the following before changing page file settings:
u
The size of the page file. If your system is equipped with a large amount of RAM, Setup
might create a page file that is unnecessarily large.
u
Drive letter reassignments. If you reassigned your drive letters, you may find it
necessary to adjust your page file settings.
To Next Page
Loading...
