ix
Preface
TDZ 2000 GL2/ExtremeZ GL2 System Setup describes setting up and configuring your TDZ
2000 GL2 or ExtremeZ GL2 system for use. This document also provides information on
operating the system, troubleshooting, and reinstalling system software.
NOTE If you have an ExtremeZ workstation, see the
ExtremeZ Customer Welcome Letter
first. The
ExtremeZ Customer Welcome Letter
provides step-by-step instructions for initial setup of an
ExtremeZ workstation.
About This Document
This document is organized as follows:
u
Chapter 1, “Setting Up the Hardware,” describes how to set up the system hardware.
u
Chapter 2, “Setting Up the Software,” describes how to set up the operating system and
associated system software.
u
Chapter 3, “Configuring the System,” describes how to configure the system for use.
u
Chapter 4, “Configuring the BIOS,” describes how to use BIOS Setup to configure the
system’s basic input/output system (BIOS).
u
Chapter 5, “Operating Notes,” describes how to use essential system features and
provides other important information.
u
Chapter 6, “Troubleshooting,” describes how to resolve common system problems.
u
Chapter 7, “Installing System Software,” describes how to install the operating system
and associated system software, if required.
u
Chapter 8, “Using System Resources,” provides information on using system resources
to configure the system for use with additional option boards.
Document Conventions
Bold
Commands, words, or characters that you key in literally.
Italic Variable values that you supply, or cross-references.
Monospace
Output displayed on the screen.
SMALL CAPS Key names on the keyboard, such as D, ALT or F3; names of files and
directories. You can type filenames and directory names in the dialog
boxes or the command line in lowercase unless directed otherwise.
To Next Page
Loading...
