29
Large Disk Access Mode
If you are using a DOS operating system (MS-DOS, Windows NT, Windows 95, Novell
DOS or PC-DOS), set the disk access mode to DOS (default). If you are using a different
operating system, set this parameter to Other.
NOTE Change this setting only prior to formatting the system disk. Erratic system behavior or file
corruption can occur if this setting is changed during normal system drive use.
MPS Version
This setting controls the Intel Multiprocessor specification revision level. Some operating
systems may require 1.1 for compatibility reasons. The available settings are 1.1 or 1.4. The
default setting is 1.4.
Advanced Screen
The Advanced screen is used to configure the system devices. Use the left and right arrow
(
←
and
→
) keys to highlight Advanced on the BIOS Setup main menu. The Advanced
screen displays as shown in the following figure.
To Next Page
Loading...
