Advisor Advanced ATSx000A(-IP) Installation and Programming Manual 111
4.3.n.3.m.2 Event type <n>
Define a type of the condition filter chosen in “4.3.n.3.m Select filter” on page
110.
The available filter types are listed in “Camera event types” on page 203.
4.3.n.3.m.3 Report as
If the filter has a custom type, it is necessary to assign a reporting event, which
occurs when the filter becomes active.
Notes
• After you leave this menu, the event is shown as a reporting code in SIA
format. See “Reporting codes used in Advisor Advanced” on page 223 for
details.
• Only particular reporting events are available.
4.3.n.4 Pics by rep ev
The camera can be also triggered by a selected reporting event.
4.3.n.4.m Select event
1 Rep. event 1
>Not used<
Select one of two reporting events to configure.
Choose an event that activates the selected camera.
Notes
• After you leave this menu, the event is shown as a reporting code in SIA
format. See “Reporting codes used in Advisor Advanced” on page 223 for
details.
• Only particular reporting events are available.
4.3.n.5 Isolated
When the camera is isolated, it does not take pictures. Also, pictures cannot be
sent to the panel.
To Next Page
Loading...
Need help?
General
