Advisor Advanced ATSx000A(-IP) Installation and Programming Manual 197
Wireless device programming
To add a wireless device, follow one of the following procedures.
Learning wireless sensors
There are two modes available for learning a wireless device, sequential and
manual.
Sequential mode
In sequential mode, you can quickly learn a range of wireless sensors.
To learn sensors in sequential mode:
1. Go to the “4.1.0 Add zone” menu described on page 95.
1>Expander 1
2 Expander 2
2. Select zone location.
3. Choose Sequential mode and press Enter.
4. Choose an input number.
Note: Depending on the hardware configuration, door/window and shock
sensors can require two wireless zones to report main sensor and auxiliary
input states. In this case, two unoccupied consecutive zones are required.
See “Two-zone RF sensors” on page 201 for more details.
5. Activate the wireless device. See “Device activation” on page 202 for more
information about activation.
If an error occurs, the keypad shows an error message and beeps seven times.
Example:
The error can occur, for example, when you try to learn a device, which is
already programmed in the wireless expander.
If the device is programmed successfully, the keypad beeps twice.
To Next Page
Loading...
Need help?
General
