Advisor Advanced ATSx000A(-IP) Installation and Programming Manual 173
Communication paths
9.3 Path options
The Path options menu allows you to configure options for available transmission
paths.
9.3.n Select path
Select the appropriate transmission path to configure its options.
Available transmission paths depend on the system configuration. By default, the
following transmission paths are available:
• PSTN
• IP
Depending on the hardware configuration, the following transmission paths may
also be available:
• ISDN
• GSM
• TDA74xx
Note: Particular options in this menu differ for specific transmission paths. For
specific options, see:
• “PSTN specific options” on page 174
• “ISDN specific options” on page 175
• “IP specific options” on page 175
• “GSM/SMS/GPRS specific options” on page 178
Common options
9.3.n.1 Path name
Use the path name screen to enter or change the transmission path name. The
name can consist of up to 16 characters.
9.3.n.2 Line fault
If the Line fault option is set to Always, the line is tested for line faults. If a line
fault is present a fault is generated in the system.
To Next Page
Loading...
