Advisor Advanced ATSx000A(-IP) Installation and Programming Manual 145
8.2.4.7 Mains fail
If the Mains fail option is set to Yes, mains supply faults require an engineer
reset.
8.2.4.8 Siren fault
If the Siren fault option is set to Yes, siren faults require an engineer reset.
8.2.4.9 Interconn fault
If the Interconnection fault option is set to Yes, interconnection faults require an
engineer reset.
8.2.4.10 Auto reset
If the Auto reset option is set to Yes, the engineering reset is performed
automatically upon the installer log in.
8.2.4.11 Dis by service
If the Disable when service in option is set to Yes, an engineer reset request is
not issued while the installer is authorized to access the system.
Note: This option is only valid if the installer requires a user authorization. See
“8.2.1 User code required” on page 143.
8.2.4.12 System code
The System code menu allows you to set the system code for engineer reset.
The code can have up to 5 digits.
The default value 0 means that the code is not set. In this case the remote reset
code generation is disabled.
If the code is set, its value and the engineering code value are used in a special
calculation to generate the reset code. See “Engineer reset procedure” on page
143 for more information.
To Next Page
Loading...
Need help?
General
