150 Advisor Advanced ATSx000A(-IP) Installation and Programming Manual
8.4.2.5 Interconnection fault
A critical error caused by communication trouble
between internal panel components
Mains fault, including external fault
Battery fault, including external fault
8.4.2.8 FTC (Failed to Communicate)
Reporting attempts are failed
An alarm in the technical zone
A fault reported by keypad
A fault reported by remote expander
All transmission paths are down (no communication)
Engineer reset requirement
8.4.3 Forced set
The Forced set option enables the forced set feature. The forced set options are
configured below.
Forced set is an option where active zones can automatically be inhibited when
setting an area.
Note: This option should be used with care. Users may not be aware which
zones are inhibited.
8.4.4 Forced set options
4 Forced set opt
>Inh unset<
The Forced set options menu defines when the forced set is possible. The
following options are available.
Table 35: Forced set options
Zone is inhibited until the area is unset.
Zone is inhibited until the exit time expires.
Zone is inhibited until its state changes to normal.
To Next Page
Loading...
Need help?
General
