180 Advisor Advanced ATSx000A(-IP) Installation and Programming Manual
If the network name is unknown (not recognized by the GSM dialler), the network
code in square brackets is displayed instead of the name, for example,
“+ [20999]”.
9.3.n.5.2.3.0 Rescan nets
Scan in progress
Please wait
The Rescan nets command performs a GSM network scan.
The scan can take a few minutes. You can cancel the scan by pressing Clear.
9.3.n.5.2.3.m Select a network
Select a network to see more options.
9.3.n.5.2.3.m.1 Network name
The Network name is the name of the GSM network. Refer to “1.2.8.6 Network
name” on page 59 for more details.
9.3.n.5.2.3.m.2 Network code
The Network code is the unique code of the GSM network. Refer to “1.2.8.7
Network code” on page 59 for more details.
9.3.n.5.2.3.m.3 Availability
The Availability values are described in “9.3.n.5.2.3 Net.scanning” on page 179.
9.3.n.5.2.3.m.4 RSSI
The Received Signal Strength Indication (RSSI) value is diagnostic information.
See also “1.2.8.8 RSSI” on page 59.
9.3.n.5.2.3.m.5 Use this net.
5>Use this net.
------------
Enter Use this network menu to connect the selected GSM network. This
replaces the network selected in “9.3.n.5.2.1 Net.selection” on page 179.
To Next Page
Loading...
Need help?
General
