Radar Target Generator - RTG1002 Edition Date: 19-Apr-18
4. REMOTE PROCEDURE CALL
4.1. Introduction
4.1.1. General
Since version 7.0.4, we have implemented a Command line control of SOME vi’s. Not all vi’s can be
controlled this way, we started with the RES, RTG2 and ADSB Tools. Later more vi’s that can be controlled
this way upon request.
Following instructions are supported since v 7.0.5.20:
-LOAD: This instruction loads a VI, when the RASS-S7 toolbox is running. You can either load or load plus
run a tool.
-START: This instruction starts a vi, similar to clicking the START button on the main panel. This instruction
also allows the preloading of the datafile (e.g. scenario) prior to running this.
-CLOSE: this instruction closes the panel of a vi.
-STOP: this instruction stops a vi, similar to clicking the STOP button on the main panel of the vi.
-RECORD: this instruction starts a recording, similar to hitting the record button on the main panel of the vi.
-STATUS: for batch file processing, this instruction allows you to retrieve the status of any VI
Following Tools are currently supported
-RES Main vi reference 60
-RES+RSE_Main_Control.vi reference 230
-RFA ADSB control vi reference 223
-RES_ADSB_Control.vi: vi reference 191
-RTG2 Remote Target Generation.vi: vi reference 247
-RTG2 On-Site Target Injection.vi: vi reference 246
4.1.2. Installation
To install this tool, you should either use the new installer of RASS-S v7.0.5.20 or later.
4.2. DETAILS
4.2.1. Prerequisites
In order to operate the Command line control, as a minimum the RASS-S7 toolbox must be running. The
toolbox will start a RPC (remote procedure call) server.
IE-UM-00601-005 RTG1002 User Manual.odt 40/48
To Next Page
Loading...