Radar Target Generator - RTG1002 Edition Date: 19-Apr-18
RASS –help creates a help message
RASS –conf arg sets the configuration file (see further) path. Default this is in the same directory as the
RASS.exe file.
RASS –logfileDir arg sets the directory for the logfile with possible error messages
RASS –logLevel arg sets the mask for the level of logging data
RASS –h arg sets the host IP number (is be set to localhost in config file)
RASS --h arg sets the host port number (should be set to 9000 in config file)
RASS –c arg Sends the actual XMLRPC command to RASS-S
4.2.3. Config file
The RASS configuration file is typically placed in the same directory as the RASS.exe file, and contains the
XML code that defines the port and host IP used by the XML RPC engine.
You can change the host parameter to a different IP address. The RASS RPC always uses port #9000.
4.2.4. Sending Commands
In practice, only the RASS –c arg syntax will be used.
Arg is the argument of the command, and should therefore be put between quotes.
As there are 6 possible commands, following arguments can be used:
IE-UM-00601-005 RTG1002 User Manual.odt 43/48
To Next Page
Loading...