Intersoft Electronics RTG1002 - 4.2.2. RPC Command Syntax and Execution

Radar Target Generator - RTG1002 Edition Date: 19-Apr-18
Figure 28: Toolbox must be running to allow RPC
4.2.2. Syntax
The commands can be sent from the command line, using the “RASS” command. The corresponding
RASS.exe can be found in the installed C: or D: disk, in the RASS-S7\LVXMLRPCServer folder.
The RASS.exe can be executed locally on RTG1002 or on a remote Windows PC. If the remote PC is
chosen then you have to copy following folder to that PC:
IE-UM-00601-005 RTG1002 User Manual.odt 41/48