29: Torque control prohibition
30: ACC/DEC prohibition
31: Counter trigger
32: Reserved
33: Cancel the frequency change setting
temporarily
34: DC brake
35: Reserved
36: Shift the command to the keypad
37: Shift the command to the terminals
38: Shift the command to the communication
39: Pre-magnetized command
40: Clear the power consumption
41: Keep the power consumption
42: Emergency stop
43–60: Reserved
61: PID pole switching
62–63: Reserved
When terminals use the ACC/DEC time selection
function, it is required to select four groups of
ACC/DEC time via state combination of these
two terminals.
This function code is used to set the polarity of
the input terminals.
When the bit is 0, the input terminal is anode.
When the bit is 1, the input terminal is cathode.
To Next Page
Loading...
Need help?
General
