INVT iMars MG Series User Manual

INVT iMars MG series grid-tied solar inverters Display panel
Setting item LCD display Instruction
MPPT of Track A and Track B; “parallel
mode” is the parallel MPPT of Track A
and Track B.
The default mode is “independent”.
The input mode setting is invisible if the
inverter is in power generation. It is only
available during DC power on and AC
power off.
Press “
” or “ ” to select the setting
mode and press “ENT” to save the
setting or “ESC” to return.
If the situation of section 5.4.8 occurs, it
is necessary to switch the DC input to
“parallel” mode.
User period
User Period
Start
: 2012- 01- 01
End : 2012
-02- 01
1
Enter into the interface and edit the user
period through “
” or “ ”. And then
press “ENT” again to the next bit. After
editing, press “ENT” to save the edition
and press “ESC” to exit.
Of which, the setting time and date
needs to be later than the system
setting, and the start time needs to be
earlier than the end time.
The setting date and time is used for the
statistical information.
- 41 -

INVT iMars MG Series Specifications

General

Brand	INVT
Model	iMars MG Series
Category	Inverter
Language	English