x SNMP – Modify SNMP settings to match with any SNMP software you wish to use for
monitoring the device.
x RTSP Configuration – Change the device’s RTSP configuration
o RTSP Server Port – TCP port used by the RTSP server.
o Session Timeout – Configure timeout in seconds for RTSP keep-alive.
o Authentication mode – Basic or Digest Authentication for RTSP connections.
x Multicast – Change the multicast IP address, starting port and TTL for all outgoing
multicast streams. To disable multicast streaming, set the multicast start port to 65535.
x Mail Server Configuration – Change email server settings to use for email alerts and
events. The mail frequency parameters allows you to limit the number of emails which
can be sent out per minute. The number of retry parameter allows you to set a limit to
the number of retries before an email transmission is aborted.
To Next Page
Loading...
