PTZ Preset Tours
Configuring Preset Tours
In IONODES devices, video inputs connected to PTZ cameras also support up to 8 preset tours.
The PTZ preset tours can be set up from the PTZ sub-section of the video input configuration
page:
To configure a PTZ preset tour, add or remove presets as needed. The tour starts at the top of
the preset list and moves to the next preset in the list after the specified time. Once the tour has
reached the end of the preset list, it moves back to the top of the list. If the preset list is empty,
the tour simply stops without moving the camera.
A preset tour supports up to 32 presets.
To configure a preset in the tour, select the preset in the preset list by clicking on it. The preset
number and duration can then be changed. Preset numbers range from 0 to 31 and durations
from 1 to 60 seconds. You can also reorder of the preset list by selecting a preset in the list and
by clicking the UP or DOWN button on the right side of the preset list to move it up or down.
The changes are applied to the tour when you click on the Save button at the bottom of the web
page.
Note: The position of each preset can be set in the Live Viewer web page of the device.
To Next Page
Loading...
