Hardware Integration
The ATOMAS-MINI has been designed to allow for flexible hardware integration to existing or
new product designs. The ATOMAS-MINI proposes four (4) mounting holes for securing to your
enclosure. In addition, a slight clearance around the board’s edge can also be used for
extrusion-type enclosures.
When integrating the ATOMAS-MINI into a product design, position the module to allow for air
circulation around the board in order to maximize the chances of heat dissipation.
Warning: Be careful not to damage the module when using mounting screws.
Temperature Considerations
The ATOMAS-MINI has been designed with industrial temp. components (-40C to +85C);
however, reaching your temperature requirements may require that you add heat sinks to certain
board-level components which generate substancial heat. Our internal testing has allowed to
confirm that with specific heatsinking, the device should be suitable for applications running
between -10C and 60C ambient temperature. Note that you may be able to obtain better results
using your own design.
To Next Page
Loading...
