#11
www.istorage-uk.com
iStorage diskAshur
®
M
2
User Manual v1.4
10. Adding a New User PIN in Admin Mode
PIN requirements:
• Must be between 7-15 digits in length
• Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3)
• Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7), (7-8-9-0-1-2-3-4), (7-6-5-4-3-2-1)
• The SHIFT (
) button can be used for additional PIN combinations - e.g. SHIFT ( ) + 1 is a different value
than just 1. See section 7, ‘Setting a User PIN Policy’.
To add a New User PIN, first enter “Admin Mode” as described in section 5. Once the drive is in Admin Mode
(solid BLUE LED) proceed with the following steps.
1. In Admin mode press and hold down both
KEY (
) + 3 buttons
Solid BLUE LED will change to blinking GREEN and
solid BLUE LEDs
2. Enter New User PIN and press KEY (
) button
Blinking GREEN and solid BLUE LEDs will switch to
a single GREEN LED blink and then back to blinking
GREEN and solid BLUE LEDs
3. Re-enter the New User PIN and press KEY (
)
button again
Blinking GREEN and solid BLUE LEDs change to a
rapidly blinking GREEN LED and finally to a solid
BLUE LED indicating a New User PIN has been
successfully configured
Important: The creation of a New User PIN must comply with the ‘User PIN Policy’ if one has been configured as
described in section 7, which imposes a minimum PIN length and whether a ‘Special Character’ has been used. The
Administrator can Refer to section 9 to check the user PIN restrictions.
Note: To immediately exit Admin Mode (solid BLUE LED), press and hold down the SHIFT ( ) button for a second - the
solid BLUE LED switches to a solid RED LED.
Note: To immediately exit Admin Mode (solid BLUE LED), press and hold down the SHIFT ( ) button for a second - the
solid BLUE LED switches to a solid RED LED.
To Next Page
Loading...
Need help?
General