#19
www.istorage-uk.com
iStorage diskAshur
®
M
2
User Manual v1.4
25. How to Configure an Admin PIN after a Brute Force attack or Reset
It will be necessary after a Brute Force attack or when the diskAshur M
2
has been reset to configure an Admin PIN before the drive can be
used.
PIN Requirements:
• Must be between 7-15 digits in length
• Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3)
• Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7), (7-8-9-0-1-2-3-4), (7-6-5-4-3-2-1)
1. In Standby state (solid RED LED), press and hold
down both SHIFT ( ) + 1 buttons
Solid RED LED will change to blinking GREEN and
solid BLUE LEDs
2. Enter New Admin PIN and press KEY (
)
button
Blinking GREEN and solid BLUE LEDs will switch to
a single GREEN LED blink and then back to blinking
GREEN and solid BLUE LEDs
3. Re-enter the New Admin PIN and press
KEY (
) button
Blinking GREEN LED and solid BLUE LED change
to BLUE LED rapidly blinking for a few seconds and
then to a solid BLUE LED indicating the Admin PIN
was successfully configured.
If the diskAshur M
2
has been brute forced or reset, the drive will be in standby state (solid RED LED). to configure an Admin PIN
proceed with the following steps.
26. Setting the Unattended Auto-Lock
To protect against unauthorised access if the drive is unlocked and unattended, the diskAshur M
2
can be set to
automatically lock after a pre-set amount of time. In its default state, the diskAshur M
2
Unattended Auto Lock time-out
feature is turned off. The Unattended Auto Lock can be set to activate between 5 - 99 minutes.
Note: To immediately exit Admin Mode (solid BLUE LED), press and hold down the SHIFT ( ) button for a second - the
solid BLUE LED switches to a solid RED LED.
To Next Page
Loading...
Need help?
General