#16
iStorage diskAshur
®
M
2
User Manual v1.4
www.istorage-uk.com
19. Enable User Read/Write in Admin Mode
To set the diskAshur M
2
back to Read/Write, first enter the “Admin Mode” as described in section 5. Once the drive is in
Admin Mode (solid BLUE LED) proceed with the following steps.
1. In Admin mode, press and hold down both “7 + 9”
buttons.
Solid BLUE LED will change to blinking GREEN and
BLUE LEDs
2. Press the KEY (
) button once
GREEN and BLUE LEDs change to a solid GREEN
LED then to a solid BLUE LED
indicating the drive is configured as Read/Write
Note: To immediately exit Admin Mode (solid BLUE LED), press and hold down the SHIFT (
) button for a second - the
solid BLUE LED switches to a solid RED LED.
When the Administrator configures the diskAshur M
2
and restricts it to Global Read-Only, then neither the Administrator nor the User can
write to the drive and both are restricted to Read-Only access. Only the Administrator is able to change the setting back to Read/Write as
described in section 21.
20. Set Global Read-Only in Admin Mode
To set the diskAshur M
2
and restrict Global access to Read-Only, first enter the “Admin Mode” as described in section 5. Once the drive
is in Admin Mode (solid BLUE LED) proceed with the following steps.
1. In Admin mode, press and hold down both “5 + 6”
buttons.
Solid BLUE LED will change to blinking GREEN and
BLUE LEDs
2. Press KEY (
) button
GREEN and BLUE LEDs will change to a solid
GREEN LED and then to a solid BLUE LED
indicating the drive has been configured and
restricts Global access to Read-Only
Note: To immediately exit Admin Mode (solid BLUE LED), press and hold down the SHIFT ( ) button for a second - the
solid BLUE LED switches to a solid RED LED.
Note: To immediately exit Admin Mode (solid BLUE LED), press and hold down the SHIFT ( ) button for a second - the
solid BLUE LED switches to a solid RED LED.
To Next Page
Loading...
Need help?
General