4-6
CONTROLS AND INSTRUMENTS
Models with Passive Entry and Start
System
1. Make sure that the parking brake
lever is fully pulled.
If your vehicle is a manual
transmission model, make sure
that the gearshift lever is in the "N"
position and then depress the clutch
pedal and brake pedal fully.
In an automatic transmission model,
make sure that the selector lever is in
the "P" position and then depress the
brake pedal fully.
2. With the pedal(s) depressed, push the
engine start/stop button. When the
engine start/stop button is pushed,
the glow plug indicator light comes on
and will then go out in approximately
0.5 seconds if the engine is warm.
If the engine is cold, it will go out
after remaining on for a maximum of
approximately 7 seconds.
3. The starter will then automatically
start the engine.
NOTE
• By using the passive entry and start
system to verify the electronic key,
the engine can be started and the
power mode can be switched.
• The engine can be started when the
power mode is either "OFF", "ACC",
or "ON".
• When the engine is cold and glow
plug warming is necessary, the
accessory power will turn off and the
audio system will remain off while
the engine is waiting to be started.
• To stop the engine while it is being
started, push the engine start/stop
button and switch the power mode
to "ACC" or "OFF".
NOTE (Continued)
Glow plug indicator light
5108428_sec04_CONTROLS AND INSTRUMENTS_P001-142.indd 6 2020/11/09 14:06:48
To Next Page
Loading...
Need help?
General
