7-11
IN CASE OF EMERGENCY
1. Push the engine start/stop button
once and the power mode will switch
to "ACC".
2. Make sure that the parking brake
lever is fully pulled.
3. If your vehicle is a manual
transmission model, make sure
that the gearshift lever is in the "N"
position and then depress the clutch
pedal and brake pedal fully.
In an automatic transmission model,
make sure that the selector lever is in
the "P" position and then depress the
brake pedal fully.
4. With the pedal(s) depressed, continue
pushing the engine start/stop button
for 15 seconds or more.
If the engine becomes unable to start for some reason, the engine may be able to be
started by performing the following operation.
CAUTION
• Because the vehicle may move unexpectedly when the engine is started,
perform the procedure after ensuring that the surrounding area is safe to do so.
• Although starting of the engine can be attempted in the "N" position for
automatic transmission models, for safety reasons, it is recommended that
starting be performed in the "P" position.
NOTE
• Perform the emergency engine starting procedure within 5 minutes of the
switching the power mode to "ACC".
• When attempting to start the engine, the glow plug indicator light will come on if
the engine is cold. In such cases, engine starting will be delayed until the glow
plugs have sufficiently warmed. Continue depressing the clutch pedal (manual
transmission models) or the brake pedal (automatic transmission models) until
the engine starts.
• When the engine does not start, contact your nearest Isuzu Dealer as soon as
possible.
Emergency Engine Starting
(Models with Passive Entry and Start System)
5108428_sec07_IN CASE OF EMERGENCY.indd 11 2020/11/13 14:57:11
To Next Page
Loading...
Need help?
General
