4-18
CONTROLS AND INSTRUMENTS
With the power mode in "ON" (models
with passive entry and start system) or the
starter switch in the "ON" position (models
without passive entry and start system),
this gauge indicates the quantity of fuel
remaining in the fuel tank. "F" means the
tank is full while "E" means the tank is
almost empty.
Fuel Gauge
NOTE
• When the remaining fuel level has
become low, the gauge will reach
the bottom level and will flash.
• After filling up the fuel tank, it takes
a while for the gauge to stabilize
after the power mode is switched
to "ON" (models with passive entry
and start system) or the starter
switch is turned to the "ON" position
(models without passive entry and
start system).
• If the fuel tank is filled with the
engine off, but the power mode in
"ON" (models with passive entry
and start system) or the starter
switch in the "ON" position (models
without passive entry and start
system), the fuel gauge takes a
while to show the correct reading. In
such a case, switch the power mode
to "OFF" or "ACC" and then to "ON"
(models with passive entry and start
system), or turn the starter switch to
the "LOCK" or "ACC" positions and
then to "ON" again (models without
passive entry and start system).
5108428_sec04_CONTROLS AND INSTRUMENTS_P001-142.indd 18 2020/11/09 14:06:49
To Next Page
Loading...
Need help?
General
