6-65
SERVICE AND MAINTENANCE
Parking Brake
Pull the parking brake lever slowly from
the fully released position while counting
the clicks produced as the lever engages
ratchet plate notches to check that it can
be raised the proper amount and the lever
is held firmly. If the number of notches is
not within the standard value range below,
adjust it to the standard value. Also, on a
dry sloping road, check that the parking
brake can hold the vehicle stationary.
Have adjustment of the parking brake and
inspections for parking brake performance
performed at an Isuzu Dealer.
Lever stroke*
6 to 9 notches
*: Number of notches before parking brake
is set when lever is pulled slowly from
released position with pull force of about
294 N (30 kgf/66 lb).
Inspection
Wheels and Tires
WARNING
• Do not drive the vehicle unless the tires are properly inflated and in safe
condition.
• If you find anything abnormal with wheel bolts, wheel nuts, disc wheels or tires
when you check them, avoid driving the vehicle and contact the nearest Isuzu
Dealer.
• If you find anything abnormal on the left wheels, check the right wheels carefully
for similar defects. A defect on a wheel may be a sign of defects on other
wheels.
The wheels have a major influence upon the safety and comfort of driving. Should any
wheel fall off the vehicle, it not only causes the vehicle to breakdown on the road and
block other traffic, but it may also lead to a serious accident. We strongly recommend
that you check the wheels and tires daily and maintain them in satisfactory condition.
Parking brake lever
5108428_sec06_SERVICE AND MAINTENANCE_P001-140.indd 65 2020/11/05 11:54:16
To Next Page
Loading...
Need help?
General
