4-127
CONTROLS AND INSTRUMENTS
Hazard Warning Flasher Switch
The hazard warning flasher is used to
signal other vehicles that your vehicle
is stationary on the road because of an
accident or component failure.
With the power mode in any mode (models
with passive entry and start system) or
the starter switch in any position (models
without passive entry and start system),
when this switch is pressed, all of the turn
signal lights and the turn signal indicator
lights flash to signal an emergency. To
turn off the hazard lights, press the switch
again.
Turn signal indicator light
ADVICE
• Do not leave the hazard warning
flasher operating for an extended
time period with the engine stopped.
Otherwise, the battery may go flat,
making it impossible to restart the
engine.
NOTE
• If you operate the hazard warning
flasher switch while the emergency
stop signal (ESS) is operating, the
ESS stops operating and the hazard
warning flashers flash normally.
5108428_sec04_CONTROLS AND INSTRUMENTS_P001-142.indd 127 2020/11/09 14:07:04
To Next Page
Loading...
Need help?
General
