4-114
CONTROLS AND INSTRUMENTS
NOTE
• By using the passive entry and start system to verify the electronic key, the
engine can be started and the power mode can be switched.
• The power mode may not change if the engine start/stop button is pressed
rapidly. Push the button carefully until the desired power mode is reached.
• In automatic transmission models, the power mode cannot be switched to
"OFF" unless the selector lever is placed in the "P" position.
• The engine start/stop button indicator light will turn on in yellow if the power
mode is in "ACC" or "ON".
• When the power mode is "ACC", "ACCESSORY MODE" will be displayed in the
MID.
• The battery power saving function will operate and the power mode will switch
to "OFF" when 60 minutes have passed with the power mode in "ACC". When
this happens, the doors will unlock. The settings for the battery power saving
function and the unlock function can be changed. To change the settings,
please contact your Isuzu Dealer.
• When the power mode is "ON", the instrument panel will be illuminated.
• If the power mode is switched from "ON" to "OFF" and the driver side door
is opened or closed while the vehicle is stopped, the steering wheel lock will
activate.
• If the engine start/stop button is pushed while the vehicle is stopped and the
power mode is "OFF", the steering wheel lock will be deactivated.
• If the engine start/stop button illumination does not come on even though the
light control switch is operates, contact your nearest Isuzu Dealer.
• When the engine start/stop button indicator light flashes in green after an
attempt to start the engine has been made, the engine will not be able to be
started due to the steering wheel lock not be unlocked. Try starting the engine
again while turning the steering wheel to the right and left.
5108428_sec04_CONTROLS AND INSTRUMENTS_P001-142.indd 114 2020/11/09 14:07:02
To Next Page
Loading...
Need help?
General
