4-191
CONTROLS AND INSTRUMENTS
WARNING (Continued)
• In the following situations, the detection function of the sensors may decrease
and the BSM may not operate properly.
- When a strong impact applied to the sensors or around the sensors misaligns
the position or direction of the sensors.
- When any part of the rear bumper near the sensors is deformed or damaged.
- When mud, snow, ice, and/or other similar substances are on the sensors or
around the sensors.
- When weather conditions are bad.
- When the temperature around the sensors becomes extremely high or low.
- When the vehicle is steeply inclined.
- When multiple vehicles approach your vehicle continuously with little space
between them.
- When vehicles in the adjacent lane are too far away from your vehicle, such
as when driving in wide lanes or on the side of a lane, etc.
- When there is variation in the difference in the speed of your vehicle and the
vehicle in the adjacent lane.
- When there is a height difference between your vehicle and vehicles in the
detection area.
- When driving on a steep slope.
- When driving continuously up and down steep slopes.
- When driving on undulating roads.
- When driving on a sharp curve or continuous curves.
- When driving on snow covered roads for a long time.
• When towing another vehicle, turn off the BSM because the system may not
operate normally.
• When the vehicle lane is very narrow and other vehicles are driving on the side
of the road, vehicles driving 2 lanes away may be detected.
WARNING (Continued)
5108428_sec04_CONTROLS AND INSTRUMENTS_P143-end.indd 191 2020/11/12 15:29:00
To Next Page
Loading...
