4-335
CONTROLS AND INSTRUMENTS
To Use the AHB
1. Set the light control switch to the
"AUTO" position.
2. Move the light control switch lever
forward to set it to the high beam
position.
AHB indicator light
When the system determines that
it is night based on the surrounding
brightness, it activates the AHB.
At this time, the AHB indicator light
comes on.
When the AHB switches the headlight
direction to upward, the high beam
indicator light comes on.
High beam indicator light
Conditions for Automatically Switching Between High
Beam and Low Beam
When all the following conditions are met, the high beam lights come on.
• When the vehicle speed is approximately 40 km/h (25 MPH) or more
• When areas in front of the vehicle are dark, such as when there is no preceding
vehicle or oncoming vehicle, or if the preceding vehicle or oncoming vehicle has
no lights on
When either one of the following conditions is met, the low beam lights come on.
• When the vehicle speed is approximately 30 km/h (20 MPH) or less
• When areas in front of your vehicle are bright, such as if there are street lights in
front of your vehicle or your vehicle is driving in an urban area
• An oncoming vehicle or the preceding vehicle turns on their lights
5108428_sec04_CONTROLS AND INSTRUMENTS_P143-end.indd 335 2020/11/12 15:29:14
To Next Page
Loading...
Need help?
General
