4-347
CONTROLS AND INSTRUMENTS
Steps for regenerating the DPD should be
taken when the DPD operator regeneration
indicator light flashes. Perform operator
regeneration as soon as possible according
to the "Operator Regeneration Procedure".
If driving is continued with the light slowly
flashing (1 Hz), the light will begin to flash
more quickly (3 Hz). If driving is continued
in this state for too long, the DPD may fail.
Therefore, perform operator regeneration
immediately according to the "Operator
Regeneration Procedure".
Operator Regeneration of DPD
ADVICE
• If the status of DPD regeneration continues to be incomplete, the malfunction
indictor light (MIL) will come on. If this occurs, have your vehicle inspected/
serviced at your Isuzu Dealer as soon as possible.
NOTE
• Depending on usage conditions, the light may begin flashing quickly (3 Hz).
If this occurs, perform operator regeneration immediately according to the
"Operator Regeneration Procedure".
DPD operator regeneration
indicator light
5108428_sec04_CONTROLS AND INSTRUMENTS_P143-end.indd 347 2020/11/12 15:29:16
To Next Page
Loading...
