Isuzu D-MAX 2020 User Manual

6-33
SERVICE AND MAINTENANCE
ADVICE
• The dirt and oil on the following
parts must be wiped off before
reinstalling the oil pan drain plug.
- Thread of the oil pan drain plug
- Thread of the oil pan drain hole
- Bolt seat surface of the oil pan
25. Measure the specified quantity of the
specified oil.
26. Pour the specified quantity of oil once
from the oil filler.
27. Install the oil filler cap.
28. Wait 5 minutes or more without
starting the engine.
29. Remove the oil dipstick and wipe off
any oil on the oil dipstick.
30. Reinsert the oil dipstick fully and then
gently remove it.
31. Check the front and back of the oil
dipstick. If the highest position is
higher than the "MIN" mark, the oil is
at the correct level.
- If the "Replenishment MAX" mark
is exceeded, drain oil until the
level is between the "MIN" and
"Replenishment MAX" marks (range
2).
32. Reinstall the oil dipstick into position
after checking the oil level.
RTUL60SH010701
Inspection
MAX
MIN
Replenishment
MAX
Oil change is needed
Adding oil is needed
1
2
RTUL60SH011401
MIN
Front Back Front Back
5108428_sec06_SERVICE AND MAINTENANCE_P001-140.indd 33 2020/11/05 11:54:10

Isuzu D-MAX 2020 Specifications

General

Brand	Isuzu
Model	D-MAX 2020
Category	Automobile
Language	English