6-52
SERVICE AND MAINTENANCE
4. Clean the drain valve at the bottom of
the air cleaner.
2. Remove the air cleaner element by
pulling it out upward.
3. Remove any dirt that has accumulated
on the inside of the air cleaner body.
Cover
Element
Body
Front
Drain valve
Front
5. Blow compressed air at a pressure of
up to 690kPa (7.0 kgf/cm²/100psi)
against the clean side of the element
to remove the dust.
ADVICE
• Do not apply compressed air to
the dirty side of the element as it
causes dust to become lodged in
the element.
Dirty side
6. Check to see if the element has been
damaged or become thin in places.
7. Reinstall the air cleaner element.
Close the air cleaner cover and fasten
the two clips of the air cleaner body.
Attach the wiring harness to the
clamp.
5108428_sec06_SERVICE AND MAINTENANCE_P001-140.indd 52 2020/11/05 11:54:15
To Next Page
Loading...
Need help?
General
