6-55
SERVICE AND MAINTENANCE
Drain plug
Priming pump
2. Loosen the drain plug and move the
priming pump up and down by hand
between ten and twenty times.
3. Fully tighten the drain plug and move
the priming pump several times.
4. Test run the engine and check that
there are no fuel leaks from the drain
plugs of the fuel filter. Also check
that the water separator (fuel filter)
warning light stays off.
Right-hand Drive
Drain plug
Priming pump
Left-hand Drive
5108428_sec06_SERVICE AND MAINTENANCE_P001-140.indd 55 2020/11/05 11:54:15
To Next Page
Loading...
Need help?
General
