6-126
SERVICE AND MAINTENANCE
ADVICE
• When installing the battery in your vehicle, ensure that it is oriented correctly
and securely fastened without any looseness. If the battery is not installed
correctly, the battery case and battery plates can be damaged as a result of
vibrations during driving.
NOTE
• In models with passive entry and start system or keyless entry system, the map
light and dome light may not illuminate if the battery terminal is connected with
a door open. If this occurs, the lights can be illuminated by closing the doors
once or by switching the power mode to "OFF" (models with passive entry and
start system) or turning the starter switch to "LOCK" position from the "ACC" or
"ON" position (models with keyless entry system).
• The ESC warning light may turn on when the battery cables are disconnected
or the battery voltage is low. The ESC function turns off while the ESC warning
light is on, but the ESC warning light will turn off by driving the vehicle normally
for a while, then the ESC function will resume. If the ESC warning light remains
on even after driving for a while, contact the nearest Isuzu Dealer.
• If battery terminals were disconnected for reasons such as for battery
replacement, it may be necessary for some time to pass before the idling stop
system operates.
Using the Battery as a Direct Power Source
The battery should not be used as a direct source of 12 V power.
If your battery must be used as a direct power source, please consult with your Isuzu
Dealer.
5108428_sec06_SERVICE AND MAINTENANCE_P001-140.indd 126 2020/11/05 11:54:22
To Next Page
Loading...
Need help?
General
