6-139
SERVICE AND MAINTENANCE
Cleaning a Belt Webbing
1. Fully extract the belt and examine for
any difference in color between the
front and back surfaces.
2. Mix one part neutral detergent into
approximately twenty parts warm
water.
3. Wet a nail brush or another similar
brush having soft bristles (of nylon or
the like) in warm water, and use this
to clean away dirt.
4. Wipe the seat belt dry using a dry
cloth, and then allow it to dry naturally
out of direct sunlight.
5. Check to be sure the seat belt retracts
and pulls out correctly.
ADVICE
• If the above-described upkeep
operations do not improve the
operation of the seat belt through
the retractor, there is a possibility
that the belt is making contact
with the door pillar trim. In this
case, arrange for inspection and
maintenance to be carried out by
your Isuzu Dealer.
• If the belt is not winding and
unwinding correctly, or if inspection
reveals problems such as
loose mountings, metal parts
deformation, webbing damage,
fraying or discoloration, arrange for
replacement to be carried out by
your Isuzu Dealer.
5108428_sec06_SERVICE AND MAINTENANCE_P001-140.indd 139 2020/11/05 11:54:23
To Next Page
Loading...
Need help?
General
