Isuzu D-MAX 2020 - Page 857

7-27
IN CASE OF EMERGENCY
WARNING
• Use fuses of the same amperage for
replacement. Do not use any other
fuses than those designated.
• Using fuses other than those
specified could result in fire or
damage to the equipment.
• If the new fuses blow right away,
contact the nearest Isuzu Dealer.
3. If the fuse appears is as shown in
the right-hand side of the diagram
at left, the fuse is blown. Replace
with a spare fuse. Spare fuses are
stored in the fuse box inside the
engine compartment and within the
instrument panel.
Replacing Relays
When replacing the relays, contact the nearest Isuzu Dealer.
NOTE
• For automatic transmission models with a passive entry and start system, if the
back light fuse is blown or has been replaced, the check system warning light
may be displayed in the multi-information display (MID). When this happens,
perform the following procedure:
- With the selector lever in the "N" position, switch the power mode to "ON"
and leave it for 5 seconds or more, or until the check system warning light
goes out.
- To start the engine, follow the normal engine starting procedure after
switching the power mode once to "OFF".
If the check system warning light continues to be displayed even after
performing the above procedures, contact the nearest Isuzu Dealer.
Starting the Engine
 →Refertopage 4-4
5108428_sec07_IN CASE OF EMERGENCY.indd 27 2020/11/13 14:57:13