iSystem iC5000 User Manual

8
Blue colored signals are trace signals.
When connecting the BlueBox to the new embedded target for the first time, double
check that the debug adapter pinout matches with the target debug connector. Note
that a mismatch can result in a hardware failure.
The following pinout is valid on the target side for the ARM ETMv3:
Signal direction
Signal
Pin
Pin
Signal
Signal direction
NC
1
2
NC
NC
3
4
NC
GND
5
6
TRACECLK
I
NC
7
8
NC
O
nSRST
9
10
NC
I
TDO
11
12
VTref
I
NC
13
14
NC
O
TCK
15
16
TRACEDATA7
I
O
TMS
17
18
TRACEDATA6
I
O
TDI
19
20
TRACEDATA5
I
O
nTRST
21
22
TRACEDATA4
I
I
TRACEDATA15
23
24
TRACEDATA3
I
I
TRACEDATA14
25
26
TRACEDATA2
I
I
TRACEDATA13
27
28
TRACEDATA1
I
I
TRACEDATA12
29
30
GND
I
I
TRACEDATA11
31
32
GND
I
I
TRACEDATA10
33
34
VCC
I
I
TRACEDATA9
35
36
TRACECTL
I
I
TRACEDATA8
37
38
TRACEDATA0
I
ETMv3 target pinout
Blue colored signals are trace signals.
When connecting the BlueBox to the new embedded target for the first time, double
check that the debug adapter pinout matches with the target debug connector. Note
that a mismatch can result in a hardware failure.
The debug adapter features resettable fuses on pins 9, 11, 12, 15, 17, 19 and 21. These protect
debug signals against overcurrent and cycle back to a conductive state after the excessive
current fades away. Signals on pins 6, 16, 18, 20 and 22-38 are protected via 47 ohm serial
resistors.
The debug adapter connects to the target via a 38-pin Mictor connector, for example Tyco
Electronics 5767055-1. A target should feature a matching part, for example Tyco Electronics
5767081-1 in SMT technology.

iSystem iC5000 Specifications

General

Brand	iSystem
Model	iC5000
Category	Measuring Instruments
Language	English