iSystem iC5000 User Manual

21
16-pin 1.27mm Custom ARM Debug Adapter
Ordering code
IC50120
This debug adapter is used to connect the iC5000 and the iC5700 BlueBox to the Cortex-M
based target. It’s used to connect to the embedded target featuring a 16-pin 1.27 mm pitch
target debug connector with the custom ARM pinout.
The debug adapter connects to the 25cm 40-pin ribbon cable coming from the BlueBox and to
the target debug connector on the other side. Refer to the BlueBox User Manual for more
details on connecting the debug adapter.
The following pinout is valid on the target side:
Signal direction
Signal
Pin
Pin
Signal
Signal direction
I
TCK
1
2
GND
O
TMS
3
4
GND
I
TDO
5
6
GND
O
TDI
7
8
GND
O
TRST
9
10
GND
I
VREF
11
12
GND
O
PRESETn
13
14
GND
Q
NC
15
16
GND
16-pin custom ARM pinout
This debug adapter features custom ARM pinout. When connecting the BlueBox to the
new embedded target for the first time, double check that the debug adapter pinout
matches with the target debug connector. Note that a mismatch can result in a
hardware failure.
The debug adapter features resettable fuses on pins 1, 3, 5, 7, 9, 11 and 13. These protect
debug signals against overcurrent. These fuses cycle back to a conductive state after the
excessive current fades away.
The adapter connects to the target via a 16-pin 1.27mm connector, for example Samtec FFSD-
08-01-N. A target should feature a matching part, for example Samtec FTSH-108-01-F-DV-K.

iSystem iC5000 Specifications

General

Brand	iSystem
Model	iC5000
Category	Measuring Instruments
Language	English