iSystem iC5000 User Manual

28
50-pin ERF8 MPC5xxx Nexus Adapter
Ordering code
IAMIC38SAM50MPC
IAMIC38SAM50MPC adapter
Some targets based on Freescale Qorivva Power Architecture or PX Series Power Architecture
microcontroller(s) (e.g. MPC5675K) can also feature a 50-pin Samtec ERF8 connector for the
Nexus debug interface instead of the popular 38-pin Mictor connector. In this case, the
IAMIC38SAM50MPC adapter is connected to the target first and then used in conjunction with
the 38-pin Mictor MPC5xxx Nexus 16-bit Debug Adapter.
It has been noticed that the 50-pin Samtec ERF8 target connector may not always
provide good mechanical stability in a vertical direction which can in worst case yield an
unreliable debug connection. Special care must be taken when connecting this debug
adapter to the target to prevent potential connection problems.

iSystem iC5000 Specifications

General

Brand	iSystem
Model	iC5000
Category	Measuring Instruments
Language	English