iSystem iC5000 User Manual

35
10-pin 1.27mm Tricore MEDC17 Debug Adapter
Ordering code
IC50160-MEDC17
This connector has been defined by Bosch and supports the JTAG debug interface only.
This debug adapter is used to connect the iC5000 and the iC5700 BlueBox to Infineon TriCore
and XC2000/XC166 based target (via the JTAG debug interface) featuring a 10-pin 1.27mm
pitch target debug connector with Bosch MEDC17 pinout.
The debug adapter connects to the 25cm 40-pin ribbon cable coming from the BlueBox and to
the target debug connector on the other side. Refer to the BlueBox User Manual for more
details on connecting the debug adapter.
The following pinout is valid on the target side:
Signal
direction
Signal description
Signal
Pin
Pin
Signal
Signal description
Signal
direction
O
Break Input
~BRK_IN
1
2
~TRST
Standard JTAG
O
Ground
GND
3
4
TCLK
Standard JTAG
O
O
Standard JTAG
TMS
5
6
~BRK_OUT
Break Output
I
O
Power On Reset
~RESET
7
8
TDI
Standard JTAG
O
I
Reference voltage
VTref
9
10
TDO
Standard JTAG
I
10-pin Bosch MEDC17 target pinout
When connecting the BlueBox to the new embedded target for the first time, double
check that the debug adapter pinout matches with the target debug connector. Note
that a mismatch can result in a hardware failure.
10-pin 1.27mm Tricore MEDC17 Debug Adapter features resettable fuses on all connected pins.
These protect debug signals against overcurrent and cycle back to a conductive state after the
excessive current fades away.
Mandatory pins on the microcontroller side are TMS, TDO, TDI, ~TRST, TCLK and ~RESET.
~BRK_IN and ~BRK_OUT signals can be used optionally.
The debug adapter connects to the target via a 10-pin 1.27mm connector, Samtec FFSD-05-01-
N. A target should feature a matching part, for example Samtec SHF-105-01-L-D-TH.

iSystem iC5000 Specifications

General

Brand	iSystem
Model	iC5000
Category	Measuring Instruments
Language	English