iSystem iC5000 User Manual

6
20-pin 1.27mm AMP Cortex Debug Adapter
Ordering code
IC50113-AMP
This debug adapter is used to connect the iC5000 and the iC5700 BlueBox to the Cortex-M
based target. It’s used to connect to the embedded target featuring a 20-pin 1.27mm
AMPMODU target debug connector with the Cortex-M pinout.
The debug adapter connects to the 25cm 40-pin ribbon cable coming from the BlueBox and to
the target debug connector on the other side. Refer to the BlueBox User Manual for more
details on connecting the debug adapter.
The following pinout is valid on the target side:
Signal direction
Signal
Pin
Pin
Signal
Signal direction
I
VTref
1
2
SWDIO / TMS
I/O / O
GND
3
4
SWCLK / TCK
O
GND
5
6
SWO / TDO
I
GND
7
8
NC / TDI
O
GND
9
10
nSRST
I/O
GND
11
12
TRCLK
I
GND
13
14
TRD0
I
GND
15
16
TRD1
I
GND
17
18
TRD2
I
GND
19
20
TRD3
I
20-pin Cortex-M pinout
Blue colored signals are parallel trace signals.
When connecting the BlueBox to the new embedded target for the first time, double
check that the debug adapter pinout matches with the target debug connector. Note
that a mismatch can result in a hardware failure.
The debug adapter features resettable fuses on pins 1, 2, 4, 6, 8 and 10. These protect debug
signals against overcurrent and cycle back to a conductive state after the excessive current
fades away. Signals on pins 12, 14, 16, 18 and 20 are protected via 100 ohm serial resistors.
The debug adapter connects to the target via a 20 -pin AMP connector, for example TE
connectivity, part number 1-111196-8. A target should feature a matching part, for example TE
connectivity part number 5-104549-2 in SMT technology.

iSystem iC5000 Specifications

General

Brand	iSystem
Model	iC5000
Category	Measuring Instruments
Language	English