To Next Page

To Previous Page

Advanced Function

1. Press [Shift]+[I-set](Function) composite key, and enter the Function menu

page.

2. Rotate the knob, select “List”, and press [Enter] key for confirmation. Enter

the List function setting page.

3. Rotate the knob to select running List file (Run), recalling List file (Recall)

and editing List file (Edit) in successive.

Run Recall Edit

4. Select different functions for setting. For detailed information about List file

editing, recalling and running, please refer to the specific introduction below.

The running, recalling and editing of List function are mutual prerequi-

sites. When the system has no existed List file, it is necessary to edit List

file, recall List file, and finally run the recalled List file.

Edit List files

1. In the List function setting interface, select Edit, and enter the List file editing

menu.

2. At first, select the number of file to be edited. At maximum of 10 List files can

be edited in this instrument.

Edit List = 1/10

3. Press [Enter] key for confirmation. Enter the List editing page.

1:List Setup

2:Edit Step= 1/1

3:Insert Step= 1/1

4:Add Step= 1/1

5:Delete Step= 1/1

6:Delete All= 1/1

7:Copy File 1 To 1

4. Select “List Setup”, and press [Enter] key for confirmation. Set the

attribute parameters of the List file in successive.

The setting method for each item is the same. Select one item, and press

[Enter] key for confirmation. When the item is under Edit state, rotate the

knob to select the configuration value or set the value. Taking the CV mode

as an example, the interface display is as follows. The displayed voltage and

current are different under different modes.

1:Mode= CV

2:End State= Last

3:Repeat= 01

ITech IT-M3300 Series User Manual

Questions and Answers: