To Next Page

To Previous Page

Advanced Function

5. Select “Edit Step= x/y”, and press [Enter] key for confirmation. Select the

number x of List step to be edited, press [Enter] key, and enter the Step

parameter editing page.

“x” means the number of step to be edited, and “y” means the total number

of steps of the List. The total numbers of steps vary automatically when the

number of editing steps increase or decrease.

• If the existing List file is a new and empty file, display Edit Step= 1/1. The

user cannot select the number of step to be edited, and can only start

editing from step 1.

• If the existing List file is an existed file, display Edit Step= 1/6. The user

can select the number of any step for editing and modification. In this

example, the number “6” is only taken as an example.

6. Rotate the knob to set the parameters of Step 1 for this List file in

successive.

Edit Step= 1/1

Voltage= 0.000V

Slope= 0.0S

Time= 0.0S

Edit Next=No/Yes

When “Edit Next” is set to “Yes”, skip to the editing interface of next step.

Repeat Step 6 to continue editing the parameter values of Step 2 of the List

file; when “Edit Next” is set to “No”, finish the parameter editing of List steps.

7. If it is necessary to adjust the existing List file, select the setting item below

for inserting, adding and deleting steps.

• “Insert Step= 2/6”: Insert one step before the selected Step 2 to add 1

step in Step 6;

• “Add Step= 2/6”: Add one after the selected Step 2 to add 1 step in Step

• “Delete Step= 2/6”: Delete the selected Step 2;

• “Delete all= No/Yes”: When “Yes” is selected, clear all steps in the

existing List file, and recover all attribute values to system default values.

When “No” is selected, do not clear steps.

• “Copy File 1 to 2”: Execute this step and copy existing List 1 file to List 2

file.

Recall and view List files

If several List files have been edited, select one List file for execution. Or, the

user can view information of the recalled List file in the recall interface.

1. In the List function setting interface, select “Recall”, and press [Enter] key

for confirmation.

2. Rotate the knob to set the number of List file to be recalled. Press [Enter]

key to enter the viewing interface.

ITech IT-M3300 Series User Manual

Questions and Answers: