ITech IT7622 Programming Guide

System Commands
Copyright© Itech Electronic Co., Ltd. 12
Example
STATus:QUEStionable:NTRansition 128
Query syntax
STATus:QUEStionable:NTRansition?
Returns
<value>
STATus:QUEStionable:CONDition?
This command is used to read the value of query condition register to get the
power meter’s status,such as ocpeak/ ocrms/ ov/op/ot
Command syntax
STATus:QUEStionable:CONDition?
Arguments
None
Returns
<value>
STATus:OPERation[:EVENt]?
This command can read the parameter from operation event register.
After executing this order, operation event register is reset.
Description of the register.:
Bit 0
CAL,Calibration
Bit 1
ST, self-testing
Bit 2
SETUP mode
Bit 3
LIST mode
Bit 4
STEP mode
Bit 5
Meter mode
Bit 6
Harmmonic mode
Bit 7
Scope mode
Bit 8
Vect mode
Command syntax
STATus:OPERation[:EVENt]?
Arguments
None

ITech IT7622 Specifications

General

Brand	ITech
Model	IT7622
Category	Power Supply
Language	English