ITech IT7622 - Wave:voltage:data[:Normalization]; Wave:current:data[:Normalization]; Wave:auto

System Commands
Copyright© Itech Electronic Co., Ltd. 43
Command syntax
WAVE:TRIGger:DELay:TIME?
Arguments
None
WAVE:VOLTage:DATA[:NORMalization]?
This command is used to obtain the voltage datas after normalization.
Command syntax
WAVE:VOLTage:DATA[:NORMalization]?
Arguments
None
Returns
<float>
WAVE:CURRent:DATA[:NORMalization]?
This command is used to obtain the current datas after normalization.
Command syntax
WAVE:CURRent:DATA[:NORMalization]?
Arguments
None
Returns
<float>
WAVE:AUTO
This command is used to set the auto mode to start waveform capture.
Command syntax
WAVE:AUTO
Arguments
None
Query syntax
None