ITech IT7622 - [Source:]Relay:mode; [Source:]Range

System Commands
Copyright© Itech Electronic Co., Ltd. 54
Command syntax
[SOURce:]RELAy:MODE <A>,<CLOSe|OPEN>
Arguments
<A>
<CLOSe|OPEN>
Query syntax
[SOURce:]RELAy:MODE? < A|B|C|ALL >
Returns
<CLOSe|OPEN>
[SOURce:]RELAy:MODE?
This command is used to query the relay mode of a phase (Normally Open,
Normally Close).
Command syntax
[SOURce:]RELAy:MODE? <A/B/C/ALL>
Arguments
<A/B/C/ALL>
Returns
<CLOSe|OPEN>
[SOURce:]RANGe
This command is used to set the voltage and current range.
Command syntax
[SOURce:]RANGe <A>,<AUTO|HIGH>
Arguments
<A>
<AUTO|HIGH>
Query syntax
[SOURce:]RANGe? <A/B/C/ALL>
[SOURce:]RANGe?
This command is used to query the voltage and current range.